MFZ612 Edge Banding Machine

PLC control screen, easy to operate, clear interface. Two modes, one-button switching: Partial bevel + Straight edge, Straight edge.

The fully automatic bevel straight edge banding machine has a 45 degree sawing unit, which crushes and cuts the beveled edges from straight edges.

Gluing the straight edge and bevel edge at the same time.

The air pressure balance device is used to make the head more stable and easier to adjust. The gas circuit design is optimized, the noise at the head is reduced, and the use efficiency of the equipment is improved.

The rough trimming knife is a flat knife. It is used to trim the excess part when sealing the veneer. Fine trimming unit: A stable frame design is adopted to reduce the jitter caused by the tool.

The small and compact edge scraping solves the problem of heavy glue line. At the same time, trim the excess sideband again to make the edge banding more beautiful. Up and down polishing mechanism to make the surface of the workpiece smoother.